alvanista [28]
And suddenly the Notepad hates me for no apparent reason. :X
Anyway. Been a long time since I posted here~ So, this tutorial is for sarajayechan. :]
Going from
to
in PSPXI - though translatable. Uses Curves and Color Balance.
1. Open your program of choice and pick your base.
2. Make a new layer, fill with #d7c9ad [
]. Set to Multiply, 100%.
3. Duplicate your base, drag it to top and set to Screen, 100%.
4. Make a new layer, fill with #061e5a [
] and set to Exclusion, 100%.
5. Duplicate your base, drag it to top and set to Overlay, 100%.
6. Make a new layer, fill it with #c1defd [
] and set it to Burn, 100%.
7. Use these textures
all by gandamu and, after moving/rotating/flipping them to your likening, set them all to Screen, 100%.
8. Go to Layers -> New Adjustement Layer -> Curves to darken the image a bit. Set the nod at the RGB panel to Input 93, Output 57*.
9. Make a new layer, fill it with #02143e [
] and set it to Exclusion, 100%.
10. Go to Layers -> New Adjustement Layer -> Color Balance. Set the Midtones to -33, 0, 69*.
11. Duplicate your base twice. Drag the both duplicates to top. Set the first one to Soft Light, 100% and the second to Soft Light, 80%.
12. Add text/border. I settled on a four pixel border in #fcf6ed.
And ta-dah~! Icon done!
*Settings vary depending on the picture you use.
Anyway. Been a long time since I posted here~ So, this tutorial is for sarajayechan. :]
Going from
to
in PSPXI - though translatable. Uses Curves and Color Balance.
1. Open your program of choice and pick your base.
2. Make a new layer, fill with #d7c9ad [
]. Set to Multiply, 100%.
3. Duplicate your base, drag it to top and set to Screen, 100%.
4. Make a new layer, fill with #061e5a [
] and set to Exclusion, 100%.
5. Duplicate your base, drag it to top and set to Overlay, 100%.
6. Make a new layer, fill it with #c1defd [
] and set it to Burn, 100%.
7. Use these textures
all by gandamu and, after moving/rotating/flipping them to your likening, set them all to Screen, 100%.
8. Go to Layers -> New Adjustement Layer -> Curves to darken the image a bit. Set the nod at the RGB panel to Input 93, Output 57*.
9. Make a new layer, fill it with #02143e [
] and set it to Exclusion, 100%.
10. Go to Layers -> New Adjustement Layer -> Color Balance. Set the Midtones to -33, 0, 69*.
11. Duplicate your base twice. Drag the both duplicates to top. Set the first one to Soft Light, 100% and the second to Soft Light, 80%.
12. Add text/border. I settled on a four pixel border in #fcf6ed.
And ta-dah~! Icon done!
*Settings vary depending on the picture you use.