making things!

Sep 21, 2008 12:28



Read more... )

Leave a comment

Comments 7

Thoughts on stripped screws knaveofhearts September 21 2008, 20:19:45 UTC
If it's the head you're stripping, check to ensure the screwdriver tip or bit you're using is the right size. They look similar but it really makes a difference. Also, if you're using a power tool, dial back the torque and that should help as well.

Reply

Re: Thoughts on stripped screws psydid September 21 2008, 20:22:42 UTC
Yeah, I found it really helped to drive the screws initially at low torque, then dial it up for the last half-inch and really put pressure on the drill head.

I've been just using the philips head that came with the drill, but until you mentioned it I forgot that I had a full set of screwdriver bits I could sort through. Good idea for next time.

Reply


tensegritydan September 21 2008, 22:57:45 UTC
Those magnetic screw holder thingies can help cuz you can put more pressure on the screw without worrying about the alignment.

Adequate pilot hole is definitely one of the most important things.

It looks great!

(I am a little worried about the rear legs getting front-to-back wobbly over time, as they are not braced in that direction and appear to be attached with just 1 fastener. A second screw would not affect the aesthetics and would strengthen it considerably.)

Reply

psydid September 22 2008, 01:25:33 UTC
The shelves are primarily joined to the legs via corner braces on the underside (where you can't see them). I used that extra screw you see for a little extra stability.

Reply

tensegritydan September 22 2008, 01:37:20 UTC
Ah, got it! It's a nice clean design.

Reply


colonelhandsome September 22 2008, 04:34:40 UTC
Beautiful work!

I was also thinking a brace between the front and back legs might be good, but depends on what it will be used for, and on such things as braces not visible in the picture, etc.

I second the suggestion to try different philips head bits. Too-pointy ones can strip the heads of bigger screws.

Congrats! I look forward to seeing what you make next, so quick was this lovely thing born!

Reply


anonymous September 27 2008, 16:15:58 UTC
It's beautiful! From a wanna-be woodworker, Aunt Susan

Reply


Leave a comment

Up